Once you have both headlight sections installed, reconnect the LEGO pieces surrounding the bonnet of the car.Ħ.) We will now install lights to the tail lights. Secure the cables down by connecting them under the black LEGO 1×8 plate, then reconnect the wheelĥ.) Repeat previous steps to install another 2 bit lights (with 30cm cable) to the headlight section on the left of the car. Pull the cables toward the back and then down toward the middle, underneath the car. Then reconnect the surrounding pieces of the headlight ensuring the cables for the bit lights are facing up in between the white triangular brick and 2 white bricks as per below.Ĥ.) Before we can reconnect the headlight section back, remove the wheel from the same side then reconnect the headlight with installed lights ensuring the cables are facing toward the inside of the car. You may need to bend the cable down on a 90 degree angle to ensure the LED component will face forward correctlyģ.) Repeat this process to install the second bit light to this headlight section. Ensure the LED component is facing the correct way. Pull it all the way through from the front side of the brick until the LED component is sitting nicely in the inside of the brick. Start by removing the following pieces to allow us to then remove one of the headlight sections as per below.Ģ.) Disassemble the headlight piece and then take one bit light with 30cm cable and thread the connector side of the cable through the back of the white 1×1 brick with hole. You can either place them directly on top of LEGO® studs or in between.ġ.) We will start with installing headlights to Ecto-1. When installing Bit Lights under LEGO® pieces, ensure they are placed the correct way up (Yellow LED component exposed). Installing Bit Lights under LEGO® bricks and plates. WARNING: Incorrectly inserting the connector can result in bent pins inside the port or possible overheating of the expansion board when connected. If a plug won’t fit easily into a port connector, do not force it. The connector side with the wires exposed should be facing toward the soldered “=” symbol as you insert into the port. With the expansion board facing up, look for the soldered “=” symbol on the left side of the port. Take extra care when inserting connectors to ports of Expansion Boards. Connecting cable connectors to Expansion Boards Do NOT forcefully join LEGO® together around cables instead ensure they are laying comfortably in between each stud.ĬAUTION: Forcing LEGO® to connect over a cable can result in damaging the cable and light. Important things to note: Laying cables in between and underneath bricksĬables can fit in between and underneath LEGO® bricks, plates, and tiles providing they are laid correctly between the LEGO® studs.
0 Comments
Leave a Reply. |